Operating steps of hard capsule filling machine model:
1. Press the green button in the "Power Switch" to turn on the power.
2. Slowly adjust the "Vibration Intensity Adjustment Knob" and turn it clockwise. At this time, the finishing disk integrated with the "Vibration Support" starts to vibrate. Touch the finishing disk with your hand and adjust it to a certain vibration intensity according to your feeling.
3. Put the powder capsule shell into the "powder capsule shell finishing plate", about 300 capsules each time. Put the capsule cap into the "capsule cap sorting tray", about 300 capsules each time. The finishing tray is made of organic glass plate, and there are many funnel shaped round holes drilled on it. The diameter of the round holes corresponds to the diameter of the capsule number.
At this time, the capsule shell of the vibrating worktable moves steadily and slowly forward and backward, thus entering the hole of the worktable one by one.
4. After about 30 seconds, the capsule shell and capsule cap will fall into the round hole with the opening facing up. If the individual opening is downward, gently press the capsule cap downward to cover it.
5. The horizontal hand-held capsule shell connecting plate (drawn at the end of the figure, has been prepared at random, and there are round holes in the connecting plate)
Push the lower part of the tray inward slightly, and the capsule shell containing powder in the tray will fall into the round hole of the adapter plate, and then take out the adapter plate. In the same way, take out the capsule cap with the capsule cap connecting plate.
6. A base area of 500 can be prepared in advance × A 500mm2 powder square plate with a height of about 10mm on four sides is filled with powder, and the joint plate of the powder capsule shell is placed flat in the powder square plate. Then cover the randomly prepared plexiglass frame on the connecting plate of the powder loading capsule, put the powder into the frame with a small bucket, scrape with the edge of the frame to fill the powder, and scrape off the excess powder.
7. Use the capsule cap fitting plate (shown at the end of the figure, there are round holes on the fitting plate), and place it on the capsule cap connecting plate, with alignment holes, which is easy to place. Turn over the capsule cap joint plate, make the capsule opening face down, and cover it on the joint plate of the powder loaded capsule shell. There are also alignment holes, which are easy to cover.
8. Put the sheathed capsule plate into the cavity under the "capsule capping forming plate", pull the "pressure bar" down by hand and put it in place. There is no need to worry about excessive force, because there is a positioning mechanism to control the downforce height. Take out the sheathed capsule plate, pour out the capsules, and complete the filling. The next board can be cycled.
Precautions for model maintenance of hard capsule filling machine:
1. This equipment is a vibrating machine, and the fastening of screws at various parts should be checked frequently. If they are loose, they should be tightened in time to prevent failure and damage.
2. The plexiglass parts (worktable plate and drug plate) shall be protected from direct sunlight and high temperature, and heavy objects shall not be placed. The drug plate must be placed vertically or horizontally to avoid deformation and damage.
3. The shell and body of the electrical appliance must be grounded to ensure safety. Cut off the power after work..
4. At the end of each day's work, the residual drugs on the machine and in the mold hole should be cleaned to keep the machine clean and sanitary, and avoid washing the machine with water. If the mold on the machine needs to be cleaned, loosen the fixing screw and take it down, which is convenient for installation.