1. The requirements for the power supply of the vacuum emulsifier should be consistent with the power supply, and the grounding wire should be reliably grounded.
2. Before each stirring, it should be jogged to check whether there is any abnormality in the stirring wall. If there is, it should be eliminated immediately.
3. Before stirring and pumping, be sure to check whether the pot is flush with the lid, and whether the pot mouth and lid are tightly sealed and reliable.
4. Before turning off the vacuum pump, the ball valve on the vacuum system purifier should be closed.
5. The vacuum pump can be started under the sealing condition of the homogenizing tank. If it is particularly necessary to turn on the air to start the pump, do not operate for more than 3 minutes.
6. It is forbidden to run the vacuum pump without oil. The ball valve on the vacuum system purifier should be closed before turning off the vacuum pump.
In addition, in the process of using the vacuum emulsifier, attention should also be paid to maintenance. The specific operations are as follows:
1. After the production is completed, the vacuum emulsifier needs to be cleaned, which not only maintains the working efficiency of the stator and rotor, but also protects the seal of the emulsifier. If necessary, a cleaning and circulation unit should be designed and installed near the perimeter.
2. After the vacuum emulsifier confirms the connection of the sealing cooling water of the machine, start the motor, and repeatedly require that the motor rotation should be consistent with the spindle rotation mark before it can run, and reverse rotation is strictly prohibited.
3. It is strictly forbidden for metal fragments or hard and difficult-to-break debris to enter the working chamber of the emulsifier, so as to avoid destructive damage to the working stator, rotor and equipment.
4. According to the different media used by the user, the inlet and outlet filters need to be cleaned regularly to prevent the reduction of the feeding speed from affecting the production efficiency.
The materials entering the studio need to be fluid, and materials with dry powder and lumps are not allowed to enter the machine directly, otherwise, the machine will be stuffy and the emulsification will be damaged.