Please pay attention to all aspects of double-sided labeling machine maintenance
Adjustment of the pressing brush device;
The center of the label brush is aligned with the label and symmetrical on both sides. The marker brush is perpendicular to the container surface.
Adjustment of the label box;
The center line of the standard box, the central axis of the standard station is tangent to the label paper, and the three points of the central axis of the target plate are in a line, adjust the tangent between the target plate and the label paper, and then move the standard box closer.
If the gap between the standard paper in the standard box and the pressure bars on both sides is too large, the standard paper will be displaced in the standard box, and a slanted mark will appear.
Adjustment of the position of the grabbing hooks of the standard box: the upper, lower, left and right grabbing hooks are on the same vertical plane and evenly exerting force on the standard paper, the mark can be grasped smoothly.
Adjustment of the label feeding roller: when there is no label, the label pressing plate can be pressed to the front end of the label box and when the label is installed, the label near the label hook finger cannot be crushed.
·Adjustment of bottle feeding star wheel, bottle feeding star wheel and bottle feeding screw rod;
When adjusting the bottle-in, bottle-out star wheel and bottle-feeding screw rod, the bottle-pressing head of the labeling machine shall prevail. First adjust the bottle feeding star wheel. When the bottle pressing head just presses the bottle, adjust the bottle feeding star wheel so that the bottle is located in the middle of the star wheel groove.
Adjustment of the bottle feeding screw rod: The bottle feeding star wheel shall prevail. When the bottle is located in the middle of the groove of the bottle feeding star wheel, adjust the screw rod so that the bottle feeding side of the screw rod is close to the bottle without displacement.
Adjustment of the bottle star wheel: When the bottle pressing head is just lifted, adjust the star wheel so that the bottle is in the middle of the groove of the star wheel.
·Station adjustment;
Adjustment of the rubber scraper and the rubber roller: There should be no gap between the rubber scraper and the rubber roller in the entire length. If there is a gap, the rubber scraper can be adjusted by adjusting the eccentric bolt.
Adjustment of the rubber roller and the target plate: the target plate and the rubber roller are only in contact with each other without any pressure. The gap is too large, and the glue on the target plate is too much, resulting in glue rejection. If the gap is too small and the contact is too tight, the glue will be squeezed away, and there is no glue on the half of the target board.
It can be realized by adjusting the bearing seat on the lower part of the rubber roller, and if necessary, adjust the bearing on the upper part of the rubber roller.

