The capsule filling machine has a fast filling speed, and the size difference of the capsule filling machine is small.
In addition, the capsule filling machine has many advantages such as fast arrangement speed, high efficiency, simple operation, convenient maintenance and low power consumption.
The fully automatic capsule filling machine has the characteristics of low energy consumption and simple replacement of molds.
How to replace the metering plate of the automatic capsule filling machine
Replacing the measuring plate: Remove the measuring plate and replace the corresponding measuring plate according to the instruction manual.
After calibrating with the calibration rod, unscrew the filling rod according to the new benchmark and refer to the depth standard of each station and tighten it. The reference plane is determined as follows:
a. After installing the metering disc, rotate the filling rod to the appropriate position (that is, when descending, the lower end of the lowest filling rod does not enter the hole of the dose disc)
b. Rotate the main motor to make the grid clamp drop to the lowest position;
c. Unscrew the filling rod so that the lower end surface of the rod is parallel to the upper surface of the dose plate;
d. Write down the indication on the scale at this time as the new datum plane;
How to replace the dispensing mechanism of the automatic capsule filling machine
The distribution mechanism needs to replace the vertical fork, the horizontal fork, the correcting seat block, and the bag feeding plate. Verify E-bar alignment.
The movements of the vertical fork and the horizontal fork are consistent, and the stroke and starting position can be adjusted by the pull rod, loosen the nut, and adjust the length of the pull rod.
How to replace the capsule lower die of the automatic capsule filling machine
Since the capsule lower die has two positioning pins, when replacing, first loosen the screws, replace the required lower die, and then tighten the screws.
Capsule upper mold, loosen the screw to remove the upper mold, and install the required upper mold. Before the screw is tightened, insert the correction rod, and when it is adjusted to rotate freely, tighten the screw.